@WSAR1-V1@@COMMENT@I-7000 IOs on Com3 or COM4@DPS@ 2)b[:Us_~eC ӽpٍ!uTM=Y *kcDumPy& qS`mPy& yR:-K\~_M=Y *kr@q]ͽpٍ!|Y]|UͽpTcDy:@NOTE@bus7000C Activate I-7000 & 87K remote I/O module's drivers with checksum and control retry frequence *** Target : Target 1: I-8417/8817/8437/8837 , I-7188EG , I-7188XG parameter: com_port : I-8xx7 ( 3 : COM3, 4 : COM4 ) , I-7188EG/XG ( 2 : COM2, 3 : COM3) com_baud : baud rate: 2400,4800,9600,19200,38400,57600,115200 host_watchdog : set to 0 disable host watdog of I-7000 modules. set not to 0 will enable it. watchdog_timer : value in hexidecimal, unit is 0.1 sec, default is 3 sec. The value should be 5 ~ FF ( 0.5 ~ 25.5 sec ) checksum : set to 0 without checksum, set to 1 with checksum retry_freq : This failed I-7000 will be request again after some bus7000 scan (1~13 scan later). Setting to 1 will poll the I/O on every scan. Setting to 2 will wait 1 scan to try again. valid value is 1 ~ 13.set value beyond 1 ~ 13 will use default retry_freq No. = 13 response_time : value in decimal, unit is 0.001 sec, default is 0 sec. The value should be 50 ~ 400 ( 0.05 ~ 0.4 sec ) Setting this time value for wait a host watchdog command Integer Input channel : showing the baud rate connected between Com port and the modules Notice : 1. Each I-7000 modules should be set as a unique address of 1 ~ 255 by "7000 utility" or "DCON utility". 2. Each I-7000 modules should be set as the same baud rate as bus7000 by "7000 utility" or "DCON utility". 3. Each I-7000 modules should be set its safe value by "7000 utility" or "DCON utility" before using watchdog protection. ICP DAS , Taiwan Feb.14,2007 @PARAM@#A+I[1,1]0205=remot #AH:ref,B #LA:com_port,3 #LA:com_baud,9600 #AA:host_watchdog,0 #AA:watchdog_timer,1E #AA:chechsum,0 #LA:retry_freq,13 #LA:response_time,0 ##END @END@